Logo Sentera
Sentera – your partner in HVAC control solutions
Search
Black-purple cover on black heat sink

Frequency inverter 400 V | 4,1 A | 1,5 kW | IP66


Product description

This IP66 frequency converter controls 400 V motors. The supply voltage is 400 VAC. The maximum motor current is 4,1 A. The motor speed can be set via the intuitive keypad or via the inputs. Configuration is simplified via 14 basic parameters and application macro functions. This frequency drive can control fans or pumps in HVAC applications. The enclosure is dust-tight and washdown ready. It offers an IP66 protection against ingress of dirt and water. The heatsink is corrosion resistant. This frequency inverter can control 400 V IE3, IE4, permanent magnet, brushless DC or synchronous reluctance motors. The integrated EMC filter is Class C1. Manufacturers code: ODE-3-140041-3F1A


Article code FI-E44041E6-19
GTIN 5401003006603
Category Outdoor rated VFD, standard operating panel
Available
Current stock 2 U.
Next arrival 24/03/2021 - 3 U.
Factory lead time 4 Week(s)
Documents

Additional specifications and description


Dust-tight design
This frequency inverter can be installed directly on processing equipment. The special ABS enclosure protects the electronics against dust and contaminants. In combination with the corrosion resistant heatsink this IP66 frequency inverter can be used for high-pressure washdown applications.

Easy to use
By selecting one of these application macros, the most important settings are pre-configured automatically. It is the ideal energy saving solution where high starting torque is not required. Typical applications are AC fans, blowers, centrifugal pumps, fume extractors and air flow controllers.

Control multiple motor types
This frequency inverter requires a 3-phase 400 V power supply. It controls standard 3-phase 400 V IE2, IE3 and IE4 induction motors. On top of that, it can also control Permanent Magnet motors, Brushless DC Motors and Synchronous Reluctance Motors.

Optimal motor control
This frequency inverter is standard equipped with an EMC filter class C1. The integrated brake chopper makes it possible to connect a brake resistor to reduce the deceleration time if necessary. Sentera HVAC sensors can be connected via the analogue input or via Modbus RTU communication.