Sentera uses cookies !

Learn more
Logo Sentera
Sentera – your partner in HVAC control solutions
Duct temperature and humidity sensor - 24 VDC supply
Duct temperature and humidity sensor - 24 VDC supply
Duct temperature and humidity sensor - 24 VDC supply
Duct temperature and humidity sensor - 24 VDC supply
Duct temperature and humidity sensor - 24 VDC supply
Duct temperature and humidity sensor - 24 VDC supply
Duct temperature and humidity sensor - 24 VDC supply

Duct temperature and humidity sensor - 24 VDC supply


This is an HVAC duct transmitter. It measures temperature and relative humidity. The supply voltage is 24 VDC. The measured values are transmitted via two analogue outputs and via Modbus RTU communication. The output type can be selected: 0-10 VDC / 0-20 mA / 0-100 % PWM. All settings can be adjusted via Modbus RTU.


Article code DSTHF-2
Category Duct temperature and humidity sensors
Available
Current stock 10 U.
Factory lead time 4 Week(s)
Documents

-   Power supply voltage 18—34 VDC
-  Selectable temperature and relative humidity ranges
-  2 selectable analogue / modulating outputs
-  Bootloader for updating the firmware via Modbus RTU communication
-  Modbus RTU (RS485)
-  Long-term stability and accuracy
-  Monitoring duct temperature and relative humidity in HVAC applications
Frequently asked questions:
In general, the difference is the supply voltage: -M version: The –M versions are Power over Modbus supplied with 24 VDC via an RJ45 socket. They do not feature a physical out, however, there is an output value generated and read via Modbus RTU. When combining multiple Sentera products via Modbus RTU, we advise to use –M or -F series. -F version: The –F version is supplied with 18 - 34 VDC via a terminal block and features physical outputs. The -F version of the product is not suited for 3-wire connection. It has separate grounds for power supply and analogue output. Connecting both grounds together might result in incorrect measurements. Minimum 4 wires are required to connect -F type sensors. When combining multiple Sentera products via Modbus RTU, we advise to use –M or -F series. -H version: The –H version is a combination of –M and –F series. They can be supplied via Power over Modbus (24 VDC via an RJ45 socket) or via the terminal block, whichever the customer prefers. The –H series also features physical outputs via the terminal blocks. -G version: The –G version features 18 – 34 VDC or 15 – 24 VAC. The -G version is intended for 3-wire connection and features a ‘common ground’. This means that the ground of the analogue output is internally connected with the ground of the power supply. In case a Sentera sensor will be connected to other, non-Sentera branded products, we advise to use –G series.
VK Icon
LinkedIn Icon
Follow us on
© 2020 Sentera. Powered by Bea Solutions