Logo Sentera
Sentera – your partner in HVAC control solutions
Search
High resolution differential pressure transmitter with 0 – 2
High resolution differential pressure transmitter with 0 – 2
High resolution differential pressure transmitter with 0 – 2
High resolution differential pressure transmitter with 0 – 2
High resolution differential pressure transmitter with 0 – 2
High resolution differential pressure transmitter with 0 – 2
High resolution differential pressure transmitter with 0 – 2

Differential pressure transmitter | 0 - 2000 Pa | 24 VDC


Product description

This HVAC sensor measures differential pressure in the range of 0 to 2.000 Pa. The supply voltage is 24 VDC. This sensor can also measure air volume flow or air velocity. The measured value is available via the analogue output and via Modbus RTU communication. The output type is selectable: 0-10 VDC / 0-20 mA / 0-100 % PWM. The four LED indicators provide a visual indication of the transmitter status and the measured values. The differential pressure range and all other settings can be adjusted via Modbus RTU.


Article code HPS-F-2K0 -2
GTIN 5401003007778
Category Differential pressure transmitters
Available
Current stock 0 U.
Next arrival 12/02/2021 - 5 U.
Factory lead time 4 Week(s)
Documents

Additional specifications and description


Differential pressure, air volume flow or air velocity?
This sensor measures differential pressure [Pa]. Based on this measurement, air volume flow [m³/hr] or air velocity [m/s] can be calculated. To calculate air volume flow based on the K-factor of the fan, use the connection set type PSET-PVC-200 or PSET-QF-200. This optional connection set can also be used to measure differential pressure. To calculate air volume flow based on the duct cross section [cm²] or air velocity [m/s], use the optional connection set type PSET-PTS-200 or PSET-PTL-200.

Visual indication
This pressure transmitter offers a clear, visual indication of the differential pressure level via the green, yellow and red LED. The green LED indicates that the pressure level is within range. When the pressure level enters the alert range, the yellow LED lights up. Red means: differential pressure out of range. The LEDs can also indicate the status of the air volume flow or air velocity. The second green LED indicates the sensor status. It is activated when power supply and Modbus RTU communication are enabled. 

How does it work?
This sensor has one analogue output. It transmits the measured differential pressure, air volume flow or air velocity proportionally. The default range of this sensor is 0 to 2.000 Pa. By default, the output transmits 0 V at 0 Pa and 10 V at 2.000 Pa. This range, the output type and all other settings can be adjusted via Modbus RTU.

Reduced installation time
The supply voltage, the analogue output and Modbus RTU communication can be connected via the cage clamp terminal block. They eliminate the need for routine maintenance and guarantee a reliable contact for solid or stranded wires. The supply voltage is 24 VDC. The ground terminals of the power supply (V-) and output (GND) are internally not connected. This means that a 4-wire cable is required to connect this sensor. Most 24 VDC power supplies offer protection against short circuit, overload and overvotage. A 24 VDC supply voltage increases the safety and reliability of your installation

High quality
The enclosure is made of high-quality r-ABS VO (UL94) plastic. This material is heat resistant, very though and offers good protection against impacts. The pressure connection nozzles are made from Aluminium. The sensor enclosure offers an IP65 protection against ingress of dirt and water. This sensor can be wall-mounted.