Logo Sentera
Sentera – your partner in HVAC control solutions
Allow us to inform you
Leave us your contact data so that we can communicate with you.


How to restore the factory default settings of a Sentera device?

Modbus RTU – how to interconnect Sentera devices
The settings of Sentera products can be changed via the parameters in the Modbus Holding registers. We distinguish between communication parameters and operational parameters.

Resetting the communication parameters is hardware-based. Such a reset is often required when communication via software is no longer possible. To reset the Modbus communication parameters to their factory default values, put a jumper on pins 1 and 2 of the P1 header for at least 5 seconds.

The operational parameters can be reset via the 3SModbus configuration software or via the Sensistant Modbus configurator by activating Holding register 10. By doing so, all operational parameters are reset to their factory default value. It is also possible to manually reset individual parameters to their factory default value via the software.

This video shows how the hardware and software reset are performed on an HVAC sensor:


Recent news
Date 25/05/2021
CO2 monitoring in schools
CO2 monitoring in schools Sentera CO2 meters help to reduce the spread of the COVID-19 virus in this school in Sint-Niklaas, Belgium. >>>
Date 16/03/2021
CO2 monitoring system to reduce the risk of COVID-19 contamination
CO2 monitoring system to reduce the risk of COVID-19 contamination Fresh indoor air reduces the risk of COVID-19 contaminations. Sentera HVAC sensors check whether there is sufficient fresh air supply. The measurements can be visualised via a 5-inch touchscreen. >>>
Date 01/02/2021
CO2 sensors with visual and audible alert
CO2 sensors with visual and audible alert Too high CO2 concentrations? Sentera CO2 sensors are now available with audible alert. On top of that, the green, yellow and red LED offer a clear, visual indication of the CO2 level. The supply voltage is 230 V or 24 V. >>>